OpenViBE forum

The OpenViBE community
It is currently Tue Jul 16, 2019 11:06 am

All times are UTC




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Wed Dec 12, 2018 3:44 pm 
Offline

Joined: Wed Nov 14, 2018 6:10 pm
Posts: 27
I have an external device that can receive instructions over serial protocol. I have a C++ code , whose functions can be used to send instructions to the device(the code encodes parameters to bits and corresponding recognizable commands and has functions to send instructions directly taking in parameters). I want to control the device from open vibe, i.e., send instructions to it after a threshold has been met. I have the present scenario giving 1s or 0's as in a matrix, indicating whether the threshold has been met or not. Where should I start from here? Do I need to program a new algorithm or box? I need to take input parameters from the user in open vibe itself and use it to send instructions.


Top
 Profile  
Reply with quote  
PostPosted: Wed Dec 19, 2018 6:38 am 
Offline

Joined: Tue Dec 04, 2012 3:53 pm
Posts: 778
Location: INRIA Rennes, FRANCE
Hi, you need to either write a new box, or use something like Python box, and then code the sending in python.

Cheers,
Jussi


Top
 Profile  
Reply with quote  
PostPosted: Wed Dec 19, 2018 10:38 am 
Offline

Joined: Wed Nov 14, 2018 6:10 pm
Posts: 27
Hey ! I went with the latter. I just wondered if there was something else I didn't know about.

Thank You


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
Americanized by Maƫl Soucaze.