Unable to see markers
Posted: Fri Sep 08, 2017 4:07 pm
Hi,
Our lab had previously written a relay tool that relays a serial signal to a specified COM port. I modified the tool to the LSL Acqiusition Server Specs so that LSL AS would see the incoming signals (markers). Yesterday, OpenVIBE designer was showing these markers during a recording session (everytime a stimulation occurred). Today however, the markers are no longer visible. I have used the template that you provided for designer:
http://openvibe.inria.fr/recording-erps/
I only used the part of the scenario that does the recording and signal display (left side) as the stim component does not apply to my neeeds since my ERP markers are coming in via a COM port.
Any ideas as to how to make the markers come back on the signal display??
Our lab had previously written a relay tool that relays a serial signal to a specified COM port. I modified the tool to the LSL Acqiusition Server Specs so that LSL AS would see the incoming signals (markers). Yesterday, OpenVIBE designer was showing these markers during a recording session (everytime a stimulation occurred). Today however, the markers are no longer visible. I have used the template that you provided for designer:
http://openvibe.inria.fr/recording-erps/
I only used the part of the scenario that does the recording and signal display (left side) as the stim component does not apply to my neeeds since my ERP markers are coming in via a COM port.
Any ideas as to how to make the markers come back on the signal display??