Page 1 of 1
Output is the same even though changes have been made
Posted: Fri Aug 19, 2016 7:58 pm
by User
I've tried to accomplish what was suggested in
viewtopic.php?f=3&t=329&p=1518&hilit=random+flash#p1518
However, I couldn't see any changes in the flash sequence even though that I rebuilt the project.
Do you have an idea why is this happening?
Thank you, any help is deeply appreciated.
Re: Output is the same even though changes have been made
Posted: Fri Sep 23, 2016 1:14 pm
by jtlindgren
Hi, make sure that whatever you're running, is using the changed resources. For example, if you compile your stuff yourself, all the stuff is in dist/. However, if you run Designer from Program Files/, it will take all the old resources from under Program Files, not your newly built ones. In the case you build yourself, launch designer that has been built from dist/. Check that 'make install' or building the install target has resulted in the modified, rebuilt stuff actually being there somewhere under dist/ as should be (instead of the old files).
Cheers,
Jussi
Re: Output is the same even though changes have been made
Posted: Sat Sep 24, 2016 7:45 pm
by User
Thank you for the reply.
This is the way how I open it. Unfortunately, I didn't notice any changes.
Any suggestions?